Back

 Racecrafts Ford  

Upload Entry
racecraft
  • racecraft
  • Site Newbie
  • Member No.: 16,113
  • Joined: 26-November 04
  • Posts: 14
  • From: Brisbane
Post #1 post 7th November 2005 - 02:35 AM
Cylinders : 6
Aspiration : Turbo
Drivetrain : RWD
Exhaust : 3 Inch
Pod Air Filter : YES
Wheels : CHROMIES
Wheel Size : 18 Inch
Estimated Power : 220ish KW

Twin Turbo Ford Goddness smile.gif
Engine Type: AU XR6 HP motor
Engine Mods: Straight LPG. Pair of Garret turbos (ex Skyline I am lead to believe) converted to distributor instead of coil pack, GRA throttle body, 1/2 inch service line from tank feeding twin B2 convertors, HAltech IG5 Ignition management system (purchased but not fitted)
Power: will hopefuly be capped at a strong 200/220rwkw but depending on the out of the box figures could be more
Exhaust: twin 2.25" from the turbos into a 3" mandrel bent system
Gearbox: Kevlar frictions and modified BTR 4 speed auto
Diff: undecided on ratio until i see some power curves and dyno sheets
Suspension: Kings SuperLow springs, copius nylon bushing and Monoroe short throw shocks on front.. standard shocks on the back (for now)
Wheels/Tyres: Front: 18" Dolce DC12 + 235*40 Nankangs.... Rear: 19" Dolce DC12 235*35 Rears

This post has been edited by racecraft: Nov 7 2005, 02:50 AM
racecrafts FORD
racecrafts FORD
racecrafts FORD
racecrafts FORD

TOP

Comments

  • Boost Network 30
  • Nick81xd
    Post #2

    nice but i understand wanting to be different but u would get more power from a big single turbo

    racecraft
    Post #3

    yes, i probably would, but you nailed it in one.. I wanted to be different smile.gif
    That why I went straight LPG too...

    It was my first go at turbo'ing a car so I jumped in at the deep end so to speak.. the extra work of 2 turbos isnt that much of an issue because I did most of the fab myself

    vex33d
    Post #4

    Nice, I like it alot! So that's what a real turbo 6 falcon looks like (BA in mind) biggrin.gif

    51YAS 33
    Post #5

    very cool good work man

    racecraft
    Post #6

    I should add its not fininshed yet, obviously... and it s an EX-Taxi with a barely run in 675000 kays on the odometer...

    Its a sort of DIY project, when its all fininshed off and tuned by a pro I hope its been worth my time ohmy.gif

    MaDDoG
    Post #7

    few 6 banga fords running lp gas and forced induction with good results, all the best smile.gif

    NINJA
    Post #8

    nice work

    1ShyVL
    Post #9

    Wow
    Thats sure different! And i must say you pulled it off great! smile.gif Well done dude!

    Tommo24
    Post #10

    holy shit! fuck me dead!

    omg!

    the annihilator!

    SkiDMaN
    Post #11

    u do some neat work... the turbo's look like t28's

    VY2NV
    Post #12

    Looks very nice indeed!

    Good luck with it. Keep us updated!

    `nigno
    Post #13

    Is that Ag-pipe ???

    racecraft
    Post #14

    QUOTE(`nigno @ Nov 8 2005, 08:44 AM)
    Is that Ag-pipe ???
    [right][snapback]5552711[/snapback][/right]


    As I said its my first time playing with Turbos and I don't realy have any idea of what Ag-pipe is? I'm guessing you mean agricultural pipe from the turbos to the airfilters? If thats what you are talking about, Its the fire resistant piping that usually goes from the filler to the tank on an LPG conversion..

    Sorry that I don't get it..
    VLTurbro
    Post #15

    Very nice mate. thumbsup.gif

    I like the look of the ELs and EFs especially Turboed ones. smile.gif

    `nigno
    Post #16

    QUOTE(racecraft @ Nov 8 2005, 09:21 AM)
    As I said its my first time playing with Turbos and I don't realy have any idea of what Ag-pipe is?  I'm guessing you mean agricultural pipe from the turbos to the airfilters?  If thats what you are talking about, Its the fire resistant piping that usually goes from the filler to the tank on an LPG conversion..

    Sorry that I don't get it..
    [right][snapback]5552879[/snapback][/right]


    Haha yeh I meant the agricultural pipe smile.gif good to hear its not... only thing that would concerne me, is the internal pattern of the piping ribbed ? or is it a smooth surface...

    Coz if it follows the contour of the outside pattern (ribbed) its not gonna be too crash hot and you should look at getting something thats gonna flow better fabricated smile.gif

    Looks like a nice conversion though, very well done thumbsup.gif

    PS:
    Looks like there is a kink in the rear turbo's pipe right up front near the filter... and i just discovered I really like saying the word ribbed biggrin.gif

    racecraft
    Post #17

    hahaha no is all good mate, the piping is smooth on the inside..

    THe gray pipe is slightly smaller diameter, hence why it kinked and was just a general pain in the arse.. I has another section of the black stuf to fix it up though

    THanks for the kind words

    J_K
    Post #18

    wicked car dude, wish my ford was as good as that...

    VINO302
    Post #19

    Tibbo is that you mate!?!?! If so that is just awsome dude!! Phat as!!

    racecraft
    Post #20

    QUOTE(VINO302 @ Nov 8 2005, 02:00 PM)
    Tibbo is that you mate!?!?! If so that is just awsome dude!! Phat as!!



    Yeh mate, how are you going Vino.. missed you at the AFD at Kedron.. the rain scare you off?

    DODelaney
    Post #21

    damn wat a weapon
    oh yea y rnt there any front indercaters
    have fun with it

    SammyB
    Post #22

    Whoa! that is amazing, big inspiration for me biggrin.gif

    Phonic
    Post #23

    QUOTE(Nick81xd @ Nov 7 2005, 08:50 PM)
    nice but i understand wanting to be different but u would get more power from a big single turbo
    [right][snapback]5551185[/snapback][/right]


    True but then you loose response and street drivabillity.

    Awsome project dude smile.gif

    colinharwood
    Post #24

    smile.gif I have a el fairmont and i wanted to do the same to my car......... and its just that....... iwanted to be different.......your car is great and good luck with further mods..........the fab was done by you and it looks really good....... the only difference is i want bigger turbos.... much bigger .......

    Redman17
    Post #25

    OMG very nice. Neva seen anything lik it. ohmy.gif

    24CIT
    Post #26

    holy shit man!!! i love your falcon!!!! Where did you get that front bar????? if you are stil in brissy when my falc isready would love to cruise with you. what wheels are you running?? thumbsup.gif thumbsup.gif

    zivie17
    Post #27

    hey hope mine looks like that one day im just sanding mine bak ready for painting mines and ex'taxi so have to get rid of the orange teheheh
    how much did it cost to put a turbo on????

    MADACCENT
    Post #28

    This is an Extremely beautiful machine !!!
    Love it good work,
    i bet it eats commodores for breakfast

    00xr8
    Post #29

    i like to dream of doing this to my fairmont... wicked car m8

    HOON69
    Post #30

    its another turbo'd ford

    welcome to brisbane smile.gif

    nah lookn good for a ex taxi smile.gif

    nice work tibbo tongue.gif

    • Member Login

      If you have a BoostCruising account enter your user name and password into the yellow box.

      Alternatively, you can quickly login with Facebook.

      If you don't have an account create one below.

      Create Account
    • Forgotten your password?
    • Login with Facebook

      Login using your Facebook account!

3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
Loading...
x